The correct way to use an electric transport truck is as follows:
Preparation before operation:
Check that there is no obvious damage to the vehicle's appearance, and that the tires are fully inflated and not excessively worn.
Make sure that the battery is fully charged and has been charged to the specified level.
Check whether the control panel, buttons and emergency stop devices are working properly.
Verify that the forks are in good condition and have no deformation or damage.
Start and drive:
Turn on the power switch, wait for the system self-check to complete, and confirm that there are no warning prompts.
Adjust the forks to the appropriate height to accommodate the cargo or pallet loading.
Use the accelerator pedal to start smoothly and control the speed, avoiding rapid starts or sudden braking.
Maintain a low and stable speed during driving, and pay attention to the surrounding environment, especially turns, narrow passages and crowded areas.
Loading and unloading cargo:
Insert the forks accurately into the pallet holes to ensure that the forks are evenly stressed.
On the premise of ensuring safety, use the lifting function to lift the cargo to the appropriate transportation height.
When unloading, the cargo should also be lowered slowly, and the forks should be placed on the ground for stability before removing the forks.
Safe operation:
Press the emergency stop button immediately in case of emergencies.
Understand and comply with the traffic rules within the factory, such as driving direction, speed limit, etc.
Do not overload and operate the electric transporter according to the rated load.
Be especially careful when going downhill or uphill, follow the principle of "slow up and fast down", and take the reverse way downhill when necessary to increase safety.
Maintenance:
Regularly clean and maintain the electric transporter, especially check the motor, battery and brake system.
Replace the hydraulic oil, check the electrical circuit and battery status according to the manufacturer's recommended schedule.
Ensure that all fasteners are in a good tightening state, including wheel bolts, fork fixing screws, etc.
Operation training:
Operators must undergo special safety operation training and pass the assessment before they can take up their posts.
Wear appropriate personal protective equipment when using electric transporters, such as helmets, reflective vests, etc.
The above steps can effectively ensure the safe and efficient use of electric transporters. Always keep safety in mind. Reasonable operation and regular maintenance are the key to increasing the service life of equipment.
