Aug 07, 2023 Leave a message

What are the solutions to the power failure of the mining dump tricycle during driving?

    If the mining dump tricycle makes a sound when it is ignited, but it cannot be ignited, it means that the vehicle still has a little power. Be careful not to force the ignition multiple times at this time, or the remaining power will be exhausted soon.

 

    There is a common and simple solution to the power failure of the mining tricycle, which is to push the cart to start. This method is also an emergency method that many drivers are familiar with. It can be used occasionally, but this method should not be used frequently. , because this method will cause some damage to the engine and clutch of the mining tricycle, so we should try to avoid using this method to start. Moreover, the way to start the cart is not to use it as soon as you want. The cart needs to find one or more helpers, and it is difficult for one person to operate.

 

    If you use the method of pushing the cart to start the mining tricycle, you must first observe whether the road conditions at the location of the vehicle are suitable for pushing the cart to start. It is easier to increase the speed of the vehicle on the downhill section. It is much more difficult to push the cart uphill, and it is not easy to increase the speed. Therefore, if the road section where the car is parked is uphill, it will be easier to start by turning the front of the car and pushing it downhill. Avoid other vehicles and pedestrians when the cart starts to avoid accidents.

 

    There is another way to start the mining tricycle is traction starting. This method is actually similar to cart starting, except that instead of manpower pushing the cart, other vehicles are used to tow the mining tricycle to start, which saves more effort. In the actual operation of towing the mining tricycle, find a traction rope with a suitable length and strong enough, and fasten both ends of the traction rope. When towing, the drivers of the two vehicles first confirm the contact signal, which is convenient for coordination and cooperation in the operation process. When starting tow, drive at a slow speed. The driver of the towing vehicle must always pay attention to the situation of the vehicle behind him, and also pay attention to the traffic conditions on the road. After the towed vehicle starts, the driver should send a signal to the front vehicle in time.

fb

    The above is the solution to the power failure parking of the electric mining tricycle during driving. If you want to know other knowledge about the mining tricycle, welcome to consult!

Send Inquiry

whatsapp

Phone

E-mail

Inquiry